I filled the holes that were left when i removed the track with some white bathroom caulk and you would have to look very close to find them. can you just leave the track and curtain as it is and mount the extended shower rod below it a bit to push the curtain out?

While mounting rods tend to look a little better than tension rods, you may need to drill into tile to install them, which can be moderately difficult. There are photos and measurements for installing an Extend-A-Shower on a 2013 TB on my profile page. They rely on the tension of your shower’s walls to remain stable and can be easily adjusted or moved. If you’re installing the rod on a tile wall, you can count the number of tiles from the ground to the rod on each side to see if the rod is even. I am not sure if you have the same size factory retractable shower frame that I have which makes the space less in size.

My shower curtains fall a little bit too short (like 4cm / couple of inches) and in consequence there is a lot of splash on the floor on the other side of the curtains. Hang your shower curtains and protect your floor from unwanted wetness with this easy to fit Chrome Extendable Shower Rod. We will need to cut all three pieces, which is what we discovered by first following the manufacturer’s instructions stating just to cut the center piece. Check out the shower rod installation tips below to learn how to easily hang a shower curtain rod so it's secure. When looking at a tension rod, make sure that the maximum length exceeds the distance between your bathroom’s walls.

We like to use the shower stall to hang damp towels, but find that when the door is closed nothing dries. The curtains are held in place with a rod and of course the obvious solution would be lower the rod. These rods are installed by inserting one end of the rod while lowering the other end into the open bracket. is a third-generation, family owned company that has been serving the needs of the RV aftermarket since 1959. Haven't tried it, but is it possible with the handle on the inside, to open the sliding door from the outside, so it can dry?I made a "frame" out of 2" X 4" lumber and used a metal cutting chop saw until I got the correct sizes that I posted. We direct the A/C vent in our 2015 Unity TB, which is just outside the shower door, into the shower area to help dry things out. If wikiHow has helped you, please consider a small contribution to support us in helping more readers like you. You shouldn’t have a problem installing a tension rod unless your shower is abnormally large or small. They serve homeowners, interior designers, architects, and contractors with a refined process, creative ideas, 4K photo-realistic renderings, and 360 Panoramic views.

You can bring this curtain to just about any seamstress and they will cut it down and hem the bottom for a "factory" look at whatever height you want. Do you think regular bathroom silicone caulk around the new screws I drill will prevent water from intruding? New: A brand-new, unused, unopened and undamaged item in original retail packaging (where packaging .We do not have a video of this but I have attached a photo for you which shows the bar in the inward and outward position.